Urgent leak or storm damage? Call 01842 773633 - answered day and nightUrgent leak? Call 01842 773633
Brandon Roofing Specialists
01842 773633 Get a Quote →

Lead Work in Hockwold

Brandon Roofers handles lead flashing, valleys, soakers and chimney details for homeowners in Hockwold, working to BS EN 12588 and giving you a straight answer on whether a repair or a full replacement is the right call.

Urgent leak or storm damage?

Call any time. Calls are answered day and night and passed straight to our roofers.

Call now: 01842 773633
Lead Work · Hockwold

Expert Lead Work
in Hockwold

Why lead work fails - and what it means for your decision

Lead is a durable material when it is installed correctly and given room to move. The failures that bring most homeowners to a decision point fall into two categories: deterioration of old lead over time, and problems caused by poor original installation. Which category your job falls into matters enormously, because it determines whether a repair will hold or whether you are paying twice by not replacing the full section now.

Lead work on UK homes is carried out to BS EN 12588, which sets out minimum thicknesses (codes) for different applications. Code 4 and 5 are standard for chimney and dormer flashings; Code 5 and 6 for valleys. Old lead that is thin, heavily oxidised, cracked or has been patched repeatedly is usually telling you it has reached the end of its serviceable life. Lead that is thick, sound and has simply lifted or cracked at one joint may well be repairable.

When repair is the right answer

Not every lead problem needs a full replacement, and a roofer who tells you it does without examining the condition of the existing lead carefully is not giving you the full picture. Repair is usually the right call when:

  • The lead sheet itself is in sound condition - thick, not excessively cracked across its face, and still flexible rather than brittle.
  • The failure is at a joint, a clip or a pointing detail rather than in the body of the sheet. A step flashing that has pulled away from its chase can be re-fixed and re-pointed without replacing the lead.
  • The lead has lifted due to thermal movement but has not cracked. Carefully re-dressing and re-fixing it with proper clips will often resolve this.
  • The leak is clearly coming from one small, identifiable area and the surrounding lead is in good order.

A well-executed repair on sound lead is not a bodge - it is the right and proportionate response to the problem. Lead that is genuinely in good condition can be repaired and continue to perform well for years.

When replacement is the better choice

There are situations where patching or repairing existing lead is false economy, and it is important to recognise them before committing to a repair that will not last.

  • The lead is thin and brittle. Very old lead that has thinned over decades, or lead that was installed below the correct code to begin with, will not hold a repair for long. It is too inflexible to dress correctly and too thin to resist frost and movement.
  • There are multiple failure points across the same section. If a chimney flashing is cracking in several places, re-fixing one area simply shifts the problem elsewhere. A full re-flash is more cost-effective over any reasonable timescale.
  • The underlying masonry or roofing is damaged. Lead that has been failing for some time often hides deterioration beneath it. Spalled brickwork on a chimney, rotted battens where a valley has been leaking, or damaged slates around a dormer all need to be dealt with at the same time. Stripping the old lead back gives you access to assess and fix this properly.
  • Previous repairs have already been made. Lead that has been patched once or twice with self-adhesive tape or lead offcuts is sending a clear message. Each patch is a sign that the underlying sheet is no longer doing its job. Continuing to patch leads to a cycle of short-term fixes and ongoing leak damage.
  • The original installation was substandard. If the lead was laid in overlength sheets without proper clips, or was bedded onto the face of the wall without being tucked into a chase, then no repair will address the root cause. The method itself is wrong and needs correcting.

The repair versus replace cost calculation

A repair to a chimney flashing might cost between £150 and £350, depending on access and the extent of the work. A full re-flash of the same chimney in Code 4 or 5 lead typically costs between £300 and £700. If the existing lead is in poor overall condition, that repair is likely to last only a few years before the next failure, at which point you pay again - and the cumulative cost exceeds what replacement would have cost at the outset.

Lead valley replacements on a domestic roof generally run from £400 to over £1,000 for longer sections, including stripping out the old material. A patch to a section of valley might cost significantly less in the short term, but if the valley is generally tired, the maths rarely favour repeated patching.

These are current indicative ranges, not fixed prices. Every job is different, and access, scaffold requirements and the condition of surrounding materials all affect the final cost.

What a proper assessment looks like

Before any lead work in Hockwold is quoted or agreed, the lead itself needs to be properly inspected. This means getting access - not just looking from the ground. Condition judgements made from a ladder top or from the ground are unreliable. The roofer needs to be at the level of the lead to assess its thickness, flexibility and the condition of the joints and fixings.

A good assessment will look at the lead itself, the masonry or roofing beneath it, the pointing around any chases, and whether the original installation method was correct. The outcome should be a clear recommendation with a reason - not just a price for whatever the roofer has decided to do.

Questions worth asking your roofer before agreeing

  • Have you physically inspected the lead, or is this a quote based on what you can see from the ground?
  • What is the condition of the lead itself - is it thick enough to repair, or is it thinning?
  • If you are recommending replacement, what is wrong with the existing lead beyond the point of failure?
  • What code of lead will you be using for any new work?
  • Is there any damage to the masonry, tiles or timber beneath the lead that needs addressing at the same time?

Getting the decision right

The honest answer is that repair versus replace is a judgement call that depends entirely on what is found when the existing lead is examined properly. There is no single rule that applies to every situation. A lead valley on a 20-year-old roof in good condition may need only a minor repair; a chimney flashing on a 50-year-old house with crumbling mortar and thin lead almost certainly needs a full strip and re-flash.

Call us to arrange a roof survey in Hockwold. We will inspect the lead properly, tell you what we find and give you a straightforward recommendation - along with a written quote for whichever option makes sense.

Why choose Brandon Roofers?

  • Free survey and itemised quote
  • Fixed price - no surprises
  • Local team

Get your free quote

No obligation · We'll call you to arrange a free visit

By submitting you agree to being contacted about your enquiry. No spam, ever.

Urgent leak or storm damage?

Call any time. Calls are answered day and night and passed straight to our roofers.

Call now: 01842 773633